EVO MFG JLU HIGH CLEARANCE LONG ARM UPGRADE, Diesel
The EVO MFG JLU High Clearance Long Arm upgrade kit through specifically�designed bracketry allows for ultimate in suspension and chassis�clearance, larger wheel travel ability, optimal suspension geometry with�increased ride quality. Clearance, ride quality, performance and ease of installation was our�focus in creating this long arm suspension system.� The front arms mount�tucked up inside nearly flush with the bottom of the frame mounting�inches above the stock front lower mounting bracket.� The rear mounting�locations for the long arm are on the side of the frame, above the�bottom giving inches of clearance over the factory locations as well.��Keeping optimal geometry while maintaining as much clearance was�critical in the design of this system.� In doing so, not only did we�raise the rear control above the frame but we raised its mounting at the�rear axle by multiple inches as well.� This allows for an incredible�ground clearance increase but just as importantly retaining flat and�optimal control arm angles giving ideal ground clearance, smooth ride�quality and long travel ability.The mounting brackets are specifically designed to require no exhaust�cutting on 3.6L Jeep Wrangler JLUs (minor grind/clearance to flange�required) and have full length hard-face mounting surfaces that weld to�your frame giving redundant and ample welding area and strength to their�mounting.� The mounting brackets align to the frame simply using�existing factory holes giving complete assurance of proper locating�during install.� Simply bolt brackets up to frame with existing hardware�and weld them in place. EVO MFG Long Arm joints feature Johnny Joints on both ends of the�control arms for restriction free articulation and motion with no�wearable and limited bond rubber.� All long arms come complete with EVO1�on vehicle adjuster making alignment a snap allowing for the ability to�adjust control arm lengths while completely installed on the vehicle at�all times.� All EVO MFG lower long arms are built with strength in mind.�These arms are made from industry leading 2.0in x .281in wall Steel DOM�Tubing. The EVO MFG JLU High Clearance Long Arm Upgrade is generally used to�convert your current short/mid arm suspension to long arm by reusing�some of your current suspension lift parts like coil springs, swaybar�links, bumpstop extension etc saving you the cost of repurchasing these�parts.� This upgrade kit can also be used in combination with EVO Front�and Rear coil over kits to maximize your vehicles on and off-road�performance.� Cutting and grinding of frame brackets required.� Welding�required.
View All Products